Search results for query: *

Just remember, those who dont "DO" .......they "teach" Go to ANY motorsports event ANYWHERE and you will not find a engine built by DV.....

I'm about 180 - 200 miles north of there

PUI interiors is an option too

Simplest and easiest way to run a clutch type fan in an early A body is to use the early cast iron water pump. Nothing wrong with it, it's what I run in mine.

All yours ! We'll figure out logistics John.

Don't watch any news

Pics.????

Wanted. 7290 large u-joint slide in yoke for 727 & later 833 transmission Thanks FABO

I will buy the B housing also if still available!

Doesn't TTI make a set of hemi headers for darts that have Al Devoric (spelling?), K frames?

https://ventura.craigslist.org/pts/d/camarillo-gasser-wheels-and-cheater/7788336198.html

To quote the o.p. in post #1, which head for a MAX performance build" ?(capitals added). For a motor with 14 to one compression, a .750 solid roller motor, with two 850s on a tunnel ram, and 471 cu inches, id probably use the speedmasters if those were my only two choices. Anything short of a...

This thing is so badass!!!

John , you can have it buddy!

GT has the extra trim and buckets & console

See the pics of Asheville and I 40?

My 70 Valiant Ute from Australia had the pentastar on the left side due to it being right hand drive. Too bad I don't have a picture of that side...

No

looks like something from the museum in Maggie Valley...yup! https://wheelsthroughtime.com/home-made-america-2/

PM also sent. Should have done that first!

There might be another issue here with DV way of picking cam, for him it's all about lsa and overlap and get the duration from those specs, a tighter lsa with same overlap would be less duration so probably lowering top end even more. Also he really don't give much info on how to pick overlap...

:rofl: :rofl::rofl:

Hey, I can turn down your bearing retainer to fit if the bolt holes are in far enough. I've read about people doing that.

Yeah. Was in southern Virginia. Don't think it got much up north of here

Good to hear that. Ya think Scott is in the clear of it?

Back in our younger days, a few friends went to a strip club in Omaha after a concert. The cops were just leaving and we asked why so many cops. Oh-a guy just got shot dead in here. needless to say, we didn't stick around.

All well here. Drove through a little corner of it. Lot of flash flooding. Drove through some fairly deep areas on low spots. Small limbs and such all over. Overall, not bad

I would love to have it!!

On the north east side of it. Pretty sure worst of it went west of them but it’s massive and it’s rotating in this general area for the next 3 days