Search results for query: *

Putting a new rear into my 1965 Dodge Dart. Cutting up a C body 8 3/4 with 11" brakes. Need verification on all measurements. There is no room for oops. Thanks

I am putting a 360 with a 727 auto, I know the motor will fit, but will the 727 go in without issues.

On my 1965 dart I am going to a newer model auto, getting rid of the cable drive. What year A body columns fit. Non power steering car.

On the hood of my 65 dart, leading edge in the center is the round emblem fot the car. I got two nuts off but can't find how to remove the third.

1965 dart, how do you get the camdy cains off, how many screws, nut or other types of hardware are holding them in place. Is there any tricks involved? thanks

I was looking at the instalation of the headliner in my 1965 dart 2dr post. does the front window have to come out so that you can get the fabric under the rubber seal and what kind of glue is used. Any other instation tips would be appriciated.

How do you replace the boot on a Ball and Trunnion driveshaft. I have a NOS mopar boot. how much of the driveshaft do i have to dissassemble?

How is this unit attached to the inner fender. there are two holes that a bracket might bolt to. does anybody have one.

I have a broken wheel stud in a 7 1/4 rear axle. Do i just hammer out the broken part of the stud, or will that damage the center diff. What is the best way to reinstall, pull it through with the nut and a spacer. Or am i just better off removing the axle.

Is there a torque spec for upper ball joints (65 dart) or is it just really tight.

I was working on the front suspension of my 65 dart, when i noticed that there was a cut in my piman arm to center link grease boot.Can you get just the boot?

My 65 dart, factory V8 car, has 10" brakes. Was 9" std and 10" optional or did all V8 cars have 10" brakes

What do I have to remove, and how to remove, the parts required to get the heater core out. To make things even worse it is a factory air car.

I have a 1965 dart. How hard is it to replace the upper control arm bushings. I am also doing the upper and lower ball joints so while it is apart i might as well do everything. Any tricks or do i just start unbolting.

Are 1964 and 1965 dart fenders the same?