Search results for query: *

Evening ! I am putting the Mopar Deep Transmission pan Kit on my 904. Could someone please verify that I have the white plastic washer in the correct spot? The rubber o ring sits correctly in the Spacer opening. I am presuming because there are no instructions that the plastic white...

Need your help. I have gear whine at 60 KMH, no other speed. It only whines at a steady speed, if I add throttle it goes away, if I let off it goes away. 8 3/4 cone type , recently added suregrip to existing 276 gear set that did not whine at all before , so I am presuming when I put the...

Need some help.. I have replaced the pinion crush sleeve on my 489 case with an eliminator kit. I am using used bearings and when I set it at only about 4 inch pounds preload, it seems the yoke has too much resistance in it... I do not have the ring gear in yet. I am just not sure how...

Need your help.. Does anyone have a Service manual tear down image for the 489 Case suregrip? I need to install a crush sleeve eliminator and need to see how it all works Thanks !!

My 904 transmission is sitting against the rubber piece at the top of the trans tunnel.. 65 valiant signet . I was thinking it would be relatively easy to cut out the mount base, fab some steel and have a welder lower the base of the crossmember , where the transmission mount rests...

I was under the car 65 Valiant, and noticed that my transmission is right tight against what appears to be a peice of rubber on the transmission tunnel ( top of Trans) near the back. Is this normal.. Should the transmission case come into contact with this ??

Looking for your thoughts.. I am re assembling my 8 3/4. Beside the paper style gasket, do I need to use any rtv sealant when I put the gearset onto the housing?? Thanks

I have to install spring perches on my recently acquired a body housing. I have a 62 b body housing with the original spring perches as set by the factory. Can i weld the new ones with the same angle as related to the center housing , as the b body housing.. I read it is 5% up...

I have been having a vibration issue for a couple of years.. tried everything.. This weekend, I went to triple check the u joints and found I could move the shaft that exits the transmission (904)... probably by close to a 1 /4 inch in all directions.. There are very small flecks of...