Search results for query: *

Don't forget labor, I would figure 2.5 hours at least at whatever your local rate is.

Those look like 9-inch drum brakes, note the top ball joint boss is twisted so I would say 9-inch brakes.

I would leave it alone; you might cause more damage trying to fix it.

@RAT ROD AL is parting a 64 Dart currently and he has a rear bumper for sale.

Save those bumper overrides (or whatever they call them) they were an option.

At some point they also put a partial VIN on the right (passenger) side of the block towards the rear of the block, stamped into a machine pad. This is not on the earlier engines.

Anybody have a parts book to get a part number and then see if any of the NOS dealers might have one.

@RAT ROD AL is parting a 64 currently

The stamping on the block by the alternator bracket mount will tell you if the block was a 225 or a 198 originally. Clean the area off and see if you can read it.

Nice flywheel I see they come in small and large hub pilot.

Bad ground somewhere, weird things like this are almost always bad grounds. Could also be a headlight bulb with a filament shorted to the other side.

I was hoping someone would post one. :thumbsup:

Exactly why I like manual transmissions, the driver determines the shift point.

I think the big 3 were more interested in selling larger wagons.

I like both Fords and Mopars but it would be sacrilege.

Not in recent years my RA kind of prevents that, but I used to go every year, the same for the Garlits Museum Mopar show, both in November.

The B&B also has the centrifugal effect (the harder you rev it the harder it grabs) that most diaphragm clutches don't, the same applies to long style clutches Ford used back in the day.

I had to edit the above a few times, but it is correct to best of my knowledge now.

They maybe the same, I will check my 63 parts catalog and see. In the 63 catalog they are the same for flywheel or torque converter they do list 2 different ones, but I suspect that is for gear reduction starter or non-gear reduction starter. 2121196 w/o the letter R and 2121195 with the letter...

They still do I saw an email recently about their support for the trades. While there are somethings, I won't buy from them they have come a long way with quality, they will never match say Snap On but some of their stuff today is as good as Craftsman.

I have wondered that myself. the 63-axle housing P/N is 2404074 what was it in the later catalog?

Ok here is a parts list and AMS shows all of it and Len Dawsons shows only the diff pinion gear. 2070024 washer for the side gears 2070023 side gear 2070025 pinion gear 2070026 washer for pinion gear 2070027 large pin for pinion gears 152229 pin that retains the large pin AMS Obsolete...

I don't think the diff gears are available anymore in the aftermarket, I will look up the original part numbers for you tomorrow and you can check with a couple of parts dealers that have NOS stock and maybe they might have them.

They normally get removed through the passenger side door with a cherry picker.

Also be careful that any hubs you buy haven't had the studs just pressed out without the swedge being cut off first, because the stud holes will be enlarged and will not be able to press in new ones. Buyer beware. One sign will be studs tack welded to the hub to hold them in. This topic has been...

I know the early A van/trucks used an adapter plate and a crank spacer to adapt the slant to a 727 for a V8, in case you didn't know.

Used is the only option that I know of.

Stories like that is why I will never live in the Orlando area again.

Hope you didn't pay too much.

I am lucky I have a tag office 2 blocks from the house and never more than a 15-minute wait.