Search results for query: *

My 67 Dart I can drive around town and on the freeway at speed just fine but when i got up a decently steep hill going 45 or faster the car will start to stumble like its losing fuel. When I step on the throttle i get nothing and i have to feather it until i get to the top and back on flat road...

My fuel pump has shut off on me a couple times after sitting and idling at a cruise for 20 minutes or longer. When trying to re fire the car it dosent come on and my regulator reads zero. Pump dosen't feel hot to the touch I'm running at about 4 psi on a stock 360 with a 650 cfm carb. And ideas...

I got this flex plate for my 73 Duster with a 360 and someone I was talking to said this flex plate is used with a zero balance converter. My question do I have to use a zero balance converter or can I still use my one with the weight on it?

Putting my 727 together and went to air check the front clutch before putting it back in the case. Noticed it was leaking air by and not engaging the clutches. Found it Is blowing air out of a hole ok the back of the clutch drum I can cover the hole with my finger and it engages like it should...

Trying to look up the information on my 727 to get the date it was built. Can't find anything with what's on the transmission or if someone els stamped it.

I'm looking for a little direction as to what would have caused this. 73 Duster 360. Tci Street fighter 727 I'm just starting to drive the car again after getting the engine back in the car and I had no issue with this transmission before I had to pull the engine. After a few in town drives car...

I'm looking to get a flex plate sheild for my car I'm planning on racing it and want the extra safety. I bought a quick time one off summit and I'm either not seeing something or I got a messed up part. I'm not seeing how the holes line up. I'm wondering if any one knows a good sheild I can get...

My 67 dart I put in a 318/904 from a 78 lebaron. Didn't touch the trans. Just new filter and fluid. Been driving it around a couple months and everything has been working without issues. Now 2 days in a row transmission acted funny both times was after it had been sitting over night. I left the...

I'm putting my 67 dart together and I'm missing the bracket that goes on the transmission for the shift linkage. If anyone has one or know where I can get just that piece?

I got a 904 from a 78 lebaron im going to use in my 67 dart. I took the gear out of a slant 6 904 I have and here's what I have and noticed the gear is smaller and seems it won't touch the outputshaft. Is there a bigger gear I can get?

On my small block I have those headers where that one tube goes right across the head. (See picture, its an older picture the only one i have right now showing that side) I have had a few plug wires burn threw lately mostly on cylinder 5 and one on 7. I had wrapped the header tube with the heat...

Looking for a new pulley for my pump. Dose any one know any online places that has them or part numbers? If someone has a good non bent one they would let go i can make a deal as well. Thanks in advanced.

I am wondering what it would take to remove the valve body in my transmission and swap in a reverse manual valve body?

When I got my car it came with the locking gas cap but they didnt have the key for it. It has a fuel cell in the trunk so I didnt think much about it. But I want it off and put a stock looking cap on it now. Dose any one have any tricks on ways to break the lock to get the cap off?

I got a 78 318 put of a Chrysler Lebaron that I'm freshening up for my 67 Dart. I noticed when I took it a part it did not have a windage tray in it and the main cap bolts do not have that part on the head to bolt a tray in. I noticed someone had been inside that engine before it has .040...

I am having a vibration while driving. The vibration happens around 45-50 mph kinda smooths out around 60 mph when I'm just cruising and is most noticeable when I let off the throttle. I have a 1973 Duster 360, 727 transmission I have a new drive shaft that was built by a shop they matched the...

73 duster big bolt patter V8 car Having the issue with the front tire being to wide and hitting the fender. The front sits pretty low so I'm thinking a previous owner adjust the torsion bars. Fronts were 14s rear was 15s I went to a new set of wheels that are all 15s. 15x9 to be exact. The...

I just swapped rear gears in my car. 73 duster 360, 727 trans I took out a 741 case that were 3.23s and i put in a 489 case 3.73s. A rebuilt case with brand new ring and pinion and all new bearings. When I went to put the drive shaft back in I realized the u-joint was to small for the 489 case...

I was trying to get my car running again as I was trying to get it to fire I noticed I did not tighten the black wire on the alternator all the way. As I was doing that the wrench got close to the valve cover and it sparked. Now the car has zero power won't crank fans dont come on when I turn...

Quick question my rockers are not available anymore.. would I be able to use a single replacement of a different brand or have to change the whole set?

I need to replace a rocker arm and I can not find one. dose any one have a part number for them? the rocker arm had 60-1.50 on them. i believe the adjuster nut was for a push rod with a 5/16th cup on it...

I am still figuring out what all the pervious owners of my car did. I'm dealing with the charging system and I noticed someone spliced a wire into the blue wire for the alternator that goes straight to the battery. No idea why they would do that and dose anyone know what or why? Thank you.

I got the car running last month after sitting for 3 years I had the engine out. But from its first start till 3 weeks ago it fired up and ran fine. Now all it dose is crank and wont fire with the key I hook up my remote starter and the car starts fine I just replaced the ignition switch and it...

I am wondering what is the proper low reverse band adjustment on a 904 connected to a 225 slant 6. I backed mine off 2-1/2 turns after tightening and it did not fix it. I could feel the transmission try to engage reverse but did not do anything I do not know how to tell if the servo is bad or if...