Search results for query: *

Decided to do a header swap over the winter, as my Hookers were pretty smashed up. So pulled all that out and ordered some TTI's. Since all that was out of the way, I decided it was a perfect time to pull the pan and change a leaking rear main. Done, all buttoned up, new headers installed, new...

Looking for passenger side headers so I can replace my crushed tubes. We're talking about Hooker Super Comp adjustable Race P/N 5303-1HKR. They have 1 7/8 primaries. Ceramic coating. Really only need tubes 4, 6 and 8 and collector, but would take the whole set off someones hands. I know Hooker...

Any thoughts about why my fuel gage (1970 ralley dash) reads full all the time. This even occurs with the battery disconnected. I am thinking bad gage myself, and wouldn't have a clue about locating just that part of the ralley cluster. Any help out there? Thanks

Jumped into the Old Duster yesterday to terrorize the streets, but found when I turned the key there was no resistance and no spring return. Just sort of turned. Then I Noticed my Tach pegged all the way, and a completely dead battery. I assume, because of the way the switch acted, that the...

I have a set of 1 7/8" Hooker ceramic headers on my SB Duster. Is it normal for the ceramic coating to dull out over time, and if so is there any way to keep them shiny and good looking for shows. Thanx!

Just got done replacing my Mopar adjustable rocker arms with some Comp Cams steel roller rockers (same 1.5 ratio). Did nothing at all to any adjustments, besides setting the valve lash, and now when shifting out of park to a drive gear, the idle drops off to where I have to give it gas to keep...

Is there any procedure that you can use to determine the stall speed of a converter. All I know is that it is a 9.5" Dynamic, mated to my 727. Help answering this appreciated!

Anyone out there know why my MC continually spits fluid. I'll get back from a cruise and have to clean fluid off the MC before it ruins the paint, which the previous unit did (main reason I installed one of the new aluminum units) It is not overfull but fluid still gets out the caps! Any ideas...

Any ideas on how to remove broken center rocker shaft hold down cap screw on 340 Head short of removing head and taking to a machine shop. Help!