Search results for query: *

Yes I do, I will take a look.

That is the ring with teeth on the passenger side correct? If so how would I adjust to combat this issue?

3.91 sure grip 489 case. They are near impossible to turn. I know you should be able to turn them by hand without breaking your back

Hey all, I just installed a new carrier in my 8 3/4 as well as new seals. I repacked the original bearings because they appeared to be in nice shape. After putting it all back together the wheels are very difficult to rotate by hand. Any thoughts as to what is causing this?

Hey all, I have a '74 360 in my Demon. COMP XE cam, Torker II, ported iron heads, and a QF 750 on top. I've been looking at purchasing the NX mainline nitrous kit, but the only issue is she retains all of her original cast rotating assembly. The motor circulated some coolant at one point and...

ISO 15x7 or 8" small bolt steelies. I currently have 14"s on the back of my Demon and cannot get a good tire for them. Thanks in advance.

Hello all, I have a '71 Demon that I'd like to put a vinyl top on. I'm 18 years old and have been building this car for the past couple of years. 360 LA, 4sp, 8 3/4 742 case (for anyone looking to sell a 3.91 gear set as well). Eventually I am going to paint the car Panther Pink and I think a...

I pray that you're still active on this forum because I gotta know what kind of wheels those are!

Hi all, I just bought a set of bows for my Demon in anticipation of installing the new headliner I got from Legendary. This is my first headliner install and I need to know whether the rear window and/or windshield need to be removed. Any tips and tricks are appreciated as well. Thanks!

No, this is a replacement transmission. However, the one I turned in as a core sat side by side with this one to ensure that both the input shafts and tail shaft lengths matched up and they did, so I don’t think crank depth is going to be an issue. As for the pilot bushing, I’m not sure if there...

Thanks for the replies! I sanded the collar and shaft (not the splines) with 400 grit sandpaper and removed all the surface rust. Are there specific sections of the input shaft that I need to grease up? Someone had told me that if you put grease on the entire shaft that it would sling it all...

I have a ‘71 Demon with a 360, and I’m getting ready to install the new tranny I bought. I also bought a new TO bearing. I’m 17 and have never installed one of these transmissions before, but the guy I bought it from said to lightly sand the collar that the TO bearing rides on, as well as the...