Search results for query: *

So I was taking the hinges off my car to clean them up, and I dropped one of the upper hinge bolts between the inner and outer body panels, apparently didn't learn my lesson and did the same thing on the other side. I have tried magnets and a grabber tool, but I haven't been able to retrieve...

I am mocking up my suspension and notice the upper control arm is very far away from the bump stop. I am using the following parts: SPC upper control arm (2nd Gen) QA1 Strut Rods Boxed stock lower control arms F-Body spindles Sway away 1.24" torsion bar Setting the QA1 Strut Rod to be free...

So I did some rust repair on the inner fenders of my car. I butt welded in some new metal and ground it all down; it turned out pretty good, but not perfect. I want to skim coat it with something to smooth it all out, but since it will be near the exhaust, I want to make sure I use something...

So I am looking to save some weight and money in my transmission build. I have 2 C-13386 extension housings (Aluminum overdrive 26 spline) and one C-99126 (Iron 1:1 30 spline). I would like to use my 30 spline main shaft with an aluminum extension housing (I'm going to use a 1:1 gearset). It...

I have a slant six flywheel for sale, its 122 tooth with a 2.16” crankshaft flange register. $100 +shipping OBO. Located in Raleigh, NC 27617

Slant six bell housing marked 3743643-1 with a date code of ‘74. It measures the larger 5.125” bearing retainer bore. Includes clutch fork, boot, inspection cover and dust cover. I also have a flywheel in good shape, it measures 11 1/2”, which should make it a 122 tooth. Asking $200 +shipping...

Offenhauser 5270 for sale, It came off a ‘68 225. It is in good shape, but the top of the adapter plate has some cut marks, and one of the screws has been cut into a cross shape. $300 +Shipping. Located near Raleigh, NC.

I was fitting up my body panels from AAR and noticed the passenger side fender has about a 1/2 inch gap from the headlight bucket/flange to the core support. I spoke with the production manager at AAR/Stinger and he said he they have been running this tool for ~20 years and hasn’t heard of this...

I have a B-Body 8 3/4 housing that was cut down to A-Body length, however it is measuring 52 1/2”, and searching around it should be 52 5/8”. Does that 1/8” matter when ordering axles, or can I go with standard length? This was sitting around my parents house for a while, so I don’t know who...

I was getting ready to weld in the bucket seat reinforcement plates on the passenger side of my car and I noticed that someone drilled the holes in the wrong spot for the outboard studs (I am going to guess this was done with the carpet installed). They also drilled holes for the inboard studs...

I am getting fiberglass body panels from my car so I am selling a Hood, Deck Lid, and hinges from my 1968 Barracuda. The hood fits 67 and 68, there is one rusted through hole on the passenger side near the hinge mounting. The other side looks OK, but has some blistered paint in the same area...

So, I am turning my 68 Barracuda into a TT/Track day car and while fixing some sheet metal issues I noticed that someone has cut the transmission crossmember. It looks like it was done for shift rod clearance; Has anyone seen this before? I have another cross member and will cut this one out and...