Search results for query: *

All I pulled off the fuel inlet fitting and is was stripped. Any suggestions on fixing? Bearwolf

All I brought a used Weber 8867 carb for my 67 273. While installing it I discovered the large brass fitting that the fuel feed line attaches to does not tighten up. It is acting like it is stripped. Two questions: 1. Is it suppose to spinning . 2. If is there a way to repair. I...

Sounds normal when I turn it over. But a good idea....

No spark. Order (2) two ecu.....

All Thanks,,I going out this morning and check for sparks. Bearwolf64

All Driving to our car club tonight, my 64 Valiant with a 67 273 4 barrel 4 speed transmission just stopped running. My wife was driving and I was right behind her. She said she heard and felt a pop thru the gas pedal and the engine just stopped running. She coasted it to the side of the road...

Herb's Parts ELECTRONIC CONVERSION KIT "A" ENGINE Product ID: P3690426 I have set at 40. Bear

All I have a stock 1967 273 with a elderbrock 4 barrel 625 cfm and manual 4 speed. How do I time it? Bearwolf50

All I should have included all my information, so here it is: 67 273 stock 4 Barrel stock 4 Speed Manual Mopar Performance Electronic Ignition Kit from Herb's Parts. The guy at the Herb's Parts tent to me to set the air gap at 40. Bear

yarcraft91 Yes Bear

All Should I set the timing at 5 or 7 BTDC? Bear

All Can I run this in a 1967 273 DUAL points engine. Bear

All Got it running. The dizzy needed rebuilding, but now the only way to turn the motor off is to disconnect the battery. Turn the ignition off does noting. Any ideas. Bear

Thanks all I will get at it again, and let you know. 67Dart273 Ya I know, I paid 160 for my harness..... Bear

All Just re-install a 1967 273 (4 barrel, 4 speed) in our Valiant. I can not get the thing to start. Can I get some schooling on sitting up the ignition timing. I am at TDC on the crank, and I verified it watching the number cylinder open and close. Thanks Bear