Search results for query: *

So as suggested above a regular cylinder hone type would work? With the "dingleberries" on it?

Really? Are they new or used? What brand?

Ok heres the other question I had. I discovered I had a bent pushrod and I think Im just going to replace them all since its cheap to do. I need to know which pushrods to order. I assume its the 7.5 inch 5/16 version for a hydraulic non adjustable valvetrain? I measured the others I have and I...

I may be able to hit up Harbor Freight and grab one if the 3 pronged one wont work. Why is one better than the other? I suppose I didnt consider that the block may be tougher than the honing stones but wouldnt have been confident enough to just dive in without being sure either.

What would you suggest I do to remedy this? All I have is a 3 pronged honing device. I think it would work its just a matter of keeping the junk from falling on the cam and in the motor and perhaps "over-honing" the bores.

I watched a video of that tool being used and unless it can be used on an assembled engine that will not be an option. That tool would slam into my cam lobes on its way through the bores not to mention the "ball" end comes off it and you have reach through the cylinder bores to extract it. My...

Ok so Im on the home stretch of putting this 360 together and finally hearing it run and have run into 2 problems and I probably make a seperate thread on the other problem. So as the title reads I have installed my lifters in their bores but just barely. The fitment was very tight and it took a...

No I don't have the manual for anything. The engine was pulled from an 82 I don't actually own the vehicle it came from. I just don't understand how there's no info on that year. Only thing I can think of is there wasnt anything significant that happened or changed in 82 so the info stops at...

Hey all I've been all over the Internet and I cannot find hardly any info on 1982 360s especially 4 barrels. What little info I do come across, a different site will say something different. I'm really trying to figure out what the stock cam in this motor is spec wise. I've heard some 360s had...