Search results for query: *

thanks for the pictures. it'll give me a place to start.

Hi all, Recently purchased the hydraulic slave set up from brewers. I've seen discussions about hydraulic clutches on here, but don't recall anything for placement. Does anyone have dimensions for the cylinder placement on the firewall, so everything lines up correctly. thanks for any help...

I'm looking at converting my clutch to a hydraulic throw out bearing. Has anyone used a McLeod or a hydromax set up? Which is better? They appear to be similar. Any advise will be appreciated. Thanks, Jon

Pic 2

Hi all. I am in need of some help. The back ground, putting a 440 4spd in a 68 barracuda. Motor, trans, drive shaft are all in and bolted down. I have bought the z bar set up and f body rod from brewers. When I bolted the z bar in, it's tilted down towards the motor. If it were straight, I'm...

Thanks, for the info. Not sure if the clip ends are in the center or not. I'll have to check it out. I wasn't sure if it was bent or not. The rod was connected to the z bar, when I bought it, but couldn't get it to connect to the pedals. I looked at brewers. I need to order new washers and...

Here are a couple pictures. If more are needed let me know. Thanks for the help. Jon

Sorry if this is a repeat question, I'm new here and haven't made it through all the old posts. I just bought a '68 Barracuda, with a 318 out of a '74 satelite and an 833 4 spd. ( I was told ) The pedals are out of a dart. My question is can you move the z bar on the shaft? I need it to move...