Search results for query: *

Thanks for the info so far. I will wire it using the starter relay.

I am starting to install a painless wiring harness into a 69 cuda that is in process of being put together. The car is not going to be stock so factory appearance and workings does not matter. It looks like the instructions show how to do it without the factory starter relay on one page and then...

Just curious if anyone makes a complete terminal and connector kit for mopar vehicles. I would like to use one of the universal wiring kits to rewire my car but I do not want to reuse my current connectors and ends. I know painless and some others make mopar specific kits. If you have used one...

Thanks for the tips. It turns out I had to look in a 1973 fsm diagram. That wire does go to the seatbelt warning system off of the splice.

Thanks for the replies so far. I must have the simplified version because it looks just like the one on mymopar site. It IS a fused circuit. If I remove the second fuse in labeled Brake LP power on the circuit goes away. I know for sure that one of the wires off the splice goes to that relay or...

Hi everyone I was just trying to clean up the wiring on my 1972 duster and I have a question on what a wire all runs to. I have the manual and I can not find in the wiring diagrams I have where it shows this wire coming to and from the fuse block. The fuse block is labeled brake and LP for the...

Well after looking through the wiring more I might have found the problem. The issue I am running into is the wiring was able to pass voltage fine but could not have handle high amps with a repair like this. All wiring even lit a halogen headlight headlight bulb good. I just stumbled on this...

Thanks again for everyones replies. I need to add that it only loses that 1v with the engine running. With the engine off and key on the blue wire at voltage regulator,ballast resistor is the same as battery voltage.

Forgot to add that I went and bought a new voltage regulator today and it actually charges more (15.8v) with new regulator

Well after checking stuff for most of day today I am still no closer to problem. I checked all bulkhead connectors and the are good. While bulkhead connectors were apart I unhooked everything that the blue wire that goes from alt to voltage regulator goes to and performed a voltage drop test on...

Thanks for the fast and accurate reply. What I found was 1.6v between positive post of battery and ignition side of ballast resistor. If I run a jumper wire between positive post of battery and ignition side of ballast the charging system voltage with it running is 14.2v. So it looks like now I...

I just replaced my alternator because of a bad bearing in old one. I thought I would check voltage with new alternator and it is showing 15.4 volts at the battery. I tried my spare voltage regulator I have and it is the same. Voltage regulator is grounded good. Wires between alternator and...

Is there anyway to make the factory gas gauge work with this fuel cell,jaz 251-016. Or is a aftermarket guage the only way? I have about 1/2 tank in cell and gauge reads empty. Thanks

I put it on my car and it works great. Yes you can do it yourself for less money but I do not think what he charges is bad. I ordered it because when I got my car together last year there was only about two weeks left to drive it before it was time to put it away for winter and I did not want to...

I believe but you may want other opinions also that if your headlight power wire is a power wire from the headlight switch that would go to 86,30 would be fused power from battery,87 would go to headlight bulbs,85 would go to ground. What are you using for a headlight switch and how is switch wired?

Did you wire it like the diagram, because the diagram is showing the switch turning on the ground circuit to the relay. Can you tell if your wire (headlamp power) has power or ground when switch is turned on.

I would make sure battery is fully charged, and cables and connections are good and not corroded. Sounds like you are not getting full amount of voltage to starter.