Search results for query: *

Yep on it-after I thought about it, didnt want to take that much amperage thru the neutral safety -f.a.b.o comes thru again - Thanks -steve

Took all the advice and wired in the stock mopar relay to remove any load on N.S.S.-ran ground on relay thru the N.S.S..thanks guys-steve

Thanks Aj-i fully understand post #6 -good explanation but since this is a 8 circuit race car we r extremely cautious about any sharp edges and routing of wires.steve

This is a full out drag car -no street and it is gutted and we are rewiring from nothing-sorry if i didnt say that.steve

I guess i didnt think the solonoid pulled that much power, i apologize if u took me the wrong way im very grateful for the help ALWAYS-i guess i still dont understand the stock wiring then, any Mopar ive had barely had a 14 or 12 ga. Wire to the solonoid from the relay, so i understand what am...

What r u guys talking about???? What load???? We have a 00 xable from batt to starter all we r doing is pulling the starter solenoid in. Im confused-the factory used a #14 ga. Wire. Thanks steve

So were in our final stages of wiring the drag car and got a question-we run a pos. Cable from battery up to starter-the momentary switch on the dash is 30amp-do i still need a relay.since were going from the switch to the neutral safety on the shifter down to the starter. Thanks Steve

We have no regulator but the one built into our one wire alternator which is brand new-Steve

WE just took ours out and had them load tested and passed with flying colors,Now i have to dig deeper,Are we being paranoid using batt. percentages instead of voltage readings on the optima's??? Sorry to hi-jack-We even bought the $300 optima charger---Steve

Zach goes out on a run at 100% and comes back at 50% with a BRAND NEW alternator installed--Steve

we are having the same problem with two brand new ones we are in the process of figuring out whats going on--Steve

Got it and also have a couple service manuals first purchase after the cars were manuals--Thanks--Steve

SORRY--70 Duster-Steve

So got the car out of storage and the back up lights don't work,4 speed car-so should there be power at the switch all the time????? The switch is located on back on trany with 2 wires going to it, I think there would be power all the time with the key on or off, bulbs look good , does reverse...

I admire your perseverance and you will to not give up--Steve

Terribly over priced,Good luck Men

I did the same as Younggun but used pex tubing (because I install it for a living) and clamped it along the top inner edge of the inner fenderwell,steve

I put batt in trunk ran a ground to the rear of the chassis with a pre-made battery cable,Ran a double o wire to the fire wall mounted with a 4 in 3/8 bolt and grounded everything with crimped ring terminals to the bolt also took pre-made batt. cables from each head to this bolt to ground the...

Yep--That's what I thought-hey it is a great system but $2000.00 or more to wire a car,It is out of most of our wallets!!!!!! No thank you--Would rather spend money elsewhere and wire the ol' fashion way-Tried and true--Steve

Cost total????????????????? Thanks Steve

Optima red here -no problems and no charging issues unless YOU let it drain down to nothing THEN follow the charging directions and they will come back,It all comes down to following directions which I believe the people with issues DON"T do because they throw the charging instructions away when...

THanks Guy's !!!!!

It even keeps spinning when ignition key is taken out and does not stop till i pull the negative cable off

66 valiant--318 stock ignition--OK just got the car off the truck and the starter will not stop spinning when engine starts,so off to the parts store to get new starter relay-Installed the relay and same thing--Starter will not stop spinning when motor starts!!!!!!!!!!! No what????? Steve

This should be stored somewhere here for reference!!!!! 67dart!! Thanks!!!! Nice simple explanation Sweet--Swifter

Is there any reason that i cannot run wires under carpet,Moved fuse block to trunk and want to run my main wires along trany hump and up to dash--Steve A,K,A Swifter:bootysha: