Search results for query: *

wanted an OE Mopar Tuff Wheel adapter to fit a Grant Tuff Wheel to a 1968 Barracuda. price shipping to 46220 thanks

Need license plate housing and lense for a 68 Barracuda, likely the same was used on all second generation Barracudas. Perhaps Darts and Valients?

The transmission that it is going into is a '74 904 if that makes a difference I found this part number 2538936,, color red, tooth count 36 thanks

Hello, I am needing one of the knobs that go on the ends of the heater control levers. There is a small Allen screw that holds it in place. Photo below has two I need one more

Need two of the plastic holders that the instrument panel bulbs fit into for a 1968 Barracuda. The holder is approximately 3/4 inch in diameter thanks

see photo. tucked under the rear bumper is a license plate light and below that in the center of the rear roll pan appears to be a mounting hole,, what I need is the rear license plate bracket for a '68 Barracuda, not sure what it looks like as cars typically have a rear license plate mounted...

for a 68 barracuda,, other year A body seats may work.. I am not up to speed on the A body seat interchange, perhaps someone here is,,, seat covering condition not a major concern thanks

wanted, transmission end drive shaft yoke for a 67 - small register 904 thanks

looking for a 150 speedo and a ecomomy / vacuum gauge for a 68 cuda

Need the drivers side head light bezel for a 68 Barracuda, also need the head light retaining ring, adjusting hardware. just purchased this 68 fastback,, some rough spots, but its basically all there, except for the item mentioned above,,car had been in storage since 1979,, thanks