Search results for query: *

I am currently breaking down a 833 transmission to rebuild for my Duster, I have the shop manual and they are calling for a C-3638 or c-3642 trool to press out the shaft for the reverse idler gear shaft. I can not find this tool anywhere. Do any of you guys have a line for this tool or an...

SOrry for the title of my fist post. I have a 8.75 Rear end not a 8.25 Ok, I have been restoring/ COnverting a 74 Duster from a 904 with 7.25 rearend to a 833 with a 8.75 rear end. I bought a rearend off Craigs list and it look pretty good to me but as it was latter found, the diff has some...

Ok, I have been restoring/ COnverting a 74 Duster from a 904 with 7.25 rearend to a 833 with a 8.75 rear end. I bought a rearend off Craigs list and it look pretty good to me but as it was latter found, the diff has some issues, at least I think it is the diff. The rearend came with new upgraded...

Can anyone tell me what the size of the bearing retainer and bell housing hole size is for a 833 OD unit. I have a Duster equipped with a OD unit and want to change to a true 4 speed. The tranny I am looking at has a 4.80 inch diameter bearing reatiner. Can I use the bell housing I have or do I...

I am restoring a 74 Duster with a 318. It had a 904 trans but has been switched out for a over drive cast iron case 4 speed. I know I have to get a different yoke for the front of the drive line but the one I got today was wider in the u joint area than the one for the 904. Can some one educate...

Can anyone help me with installing my Clutch- Satrter saftey switch in my 74 Duster. I have a NOS switch but can not for the life of me find were to install it. Can anyone post a picture of one installed or some data on how to get htis done. I have found nothing in my shop manuals. I must be...

I have a 74 Duster that I am restoring/ converting. I have the car stripped down and almost ready to start on the drive line parts. I have bought a 4 speed trans and a center hump to convert. I am not sure how to move forward with cutting the floor. Can any one help?