Search results for query: *

I just put a freshly rebuilt 727 in my dart, I swaped the automatic valve body for a TCI reverse manual valve body, followed all the instructions. Then I bolted the transmission in and was installing the drive shaft and realized I couldn't turn the drive shaft, I checked it in all gears and I...

Going to be putting my rearend this week and looking for a little advice on the pinion angle. I am getting some conflicting advice. The tailshaft of my transmission is currently at 0* The car will be used 50 street 50 strip. Some have told me to set the pinion angle to 0* so the transmission...

Its time for a new tranmission, my front seal started leaking today, and I have been having shifting problems for a while. I am looking for suggestions. Would like reverse manual valve body. I've been looking at the TCI competition series which Summit Racing has for $850.00

I have a weird problem. I have a 727 behind my 440, and when I go from park or neutral to drive it goes in to 1st real soft then a couple seconds I feel a jerk and the car lunges forward and it feels like it is really going into gear. If I try to take off before I feel the lunge the...

I got a new of stainless steel braided transmission lines with 6an fitting on the transmission side and 6 SAE fittings (5/16 inverted flare) on the radiator. I got them on ebay and one was about 12" too long, I had asked if I could send it back and simply get a new one 12" shorter with the same...

I am trying to isolate the vibration I am getting above 40 mph. I just replaced the rear transmission seal and noticed it is leaking again today with only 20 miles on it. I am curious how much play the rear shaft on the transmission should have. I did take the drive shaft in to get balanced...

The rear seal in my transmission is leaking. How easy is this to replace and are they seals readily available?

What is the correct routing of the transmission cooling lines. Front of transmission to (passenger side of radiator or drivers sides). And rear of transmission to (passenger side of radiator or drivers sides)? As usual thanks. I should also point out I have a big block 727 trans and 65 dart...

What size are the threads on the transmission cooler lines on a 727 . I am guessing 3/8 but want to be sure

I am going with a front plate motor mount on my 65 dart with a 440, was wondering what would be the best transmission mount? The one in it is shot. Would there be a problem with using a solid mount? Or should I just go polyuerethane? Also any idea who has the best price on early a-body...

Figured it out.

How do I know by looking at my transmission if I have 904 or 727. It's in a 65 not sure if it is original or not, but I need to buy a kick down cable and need to figure out which one I have.