Search results for query: *

I rebuilt a '79 model non lockup 727. I put billet servos, red clutches, red bands, CRT manual valvebody, etc into it. I had a new pump here and decided to use it. Upon starting it, I have reverse but no forward gears. I compared the '79 pump with a '74 pump I have and noticed a BIG difference...

I've supposedly got a TCI valvebody in my 727. The trans builder put the and several parts into my trans. After giving him two chances to fix it, I tore I to myself and built it. The valvebody has no markings on it and it looks like a used old regular valvebody with a modest shift kit in it. The...

I've researched this topic all over but never found a sure answer. I installed my 727 about 2 years ago and used a Milodon braided stainless dipstick. I put a transgo shift kit in it and a 2800 stall. The engine made 304 HP at the wheels and it went 12.80 in the 1/4. It NEVER felt like it...

I just picked up my transmission from the rebuild shop and it was supposed to get a good performance rebuild and a TCI valve body. It was a stock transmission from a 74-75 truck that I had installed a transgo shift kit into Everything had worked fine and I was happy with the shifts until 3rd...

I have a pretty bad leak coming from the speedo housing on my 727. I bought the trans as a low mile rebuild. I installed it over a year ago when doing a slant 6 to V8 swap. The speedometer hasn't worked since. I ordered the correct 36 tooth red gear to match the 3.55 gears and a seal kit. It had...

I have a 727 that I bought as a very low mileage pull out. It had been rebuilt and put into a truck and then sold. The new owner put his own drivetrain in the truck and sold me the trans. I opened it and installed a trans go shift kit. Used a lokar kickdown cable and bolted it behind a 5.9...

I'm pretty sure I know the answer here, but here it goes. I'm finally getting around to putting the motor in my 70 dart. It's a Magnum 360 and a 727 using the transdapt /6 to small block mounts. I attempted to install my new SS cooler lines that I picked up from summit. Neither of them fit...

I have a shop here locally in Oklahoma city cutting an E body axle down to A body spec. It should be done today or tomorrow. My question is, is there any demand for a housing that has been cut down? I have another complete 8.75 from a truck or van most likely. It's a 2.7x open diff. So not very...