Search results for query: *

66 Cuda 273 Commando Holley 600cfm mechanical double pumper & Edelbrock Performer Intake. Setup is 20yrs old. Carb rebuilt about 10yrs ago. Been having this issue for awhile. Usually only appeared after car sat for awhile in colder months. Attributed it to probably gas that leaked and...

A friend is needs a 273 Commando 4bbl cast iron intake for his '67 Barracuda. Correct me if I'm wrong but a '65 and '66 Comm. Intake will interchange but are they the same part numbers? If not what are the part numbers for each year, specifically 1967?

273 Commandos - What's your oil pressure reading @ idle, cruising & WOT? Is worth swapping to MOPAR hipo distributor vs. stock elctronic distributor ? 1.) I know it will vary depending on type of oil and mods so state what you've done to your 273 and what's the oil press. # Currently mine is...

I've been told that a Harmonic Balancer for 1966 273 Commando is not the same for later, '67 & up 273's. I was told that the numbers are read from the passenger side but as seen in the photo my timing numbers are facing the driver side. The harmonic balancer itself is located more to the...

Need to get a new harmonic balancer dampner for '66 Barracuda 273 Commando - mild build up, about 285hp. She's a cruiser and occaisional 6000rpm shifting :D and I drive her about 500 - 700 miles a year...Any suggestions? I saw that Jegs & Summit have some inexpensive ones for around $70.00...

Just wondering....last year I installed an AutoMeter short sweep electrical oil press gauge and until today it always reads 38 - 40psi at idle or WOT even with me shifting over 5000rpm in 80+ degrees weather and when the weather is below 60 degrees she's a little higher at 43 ... Today during...

273 Commando engine - Holley 600 double pumper - HiPo cam, Edelbrock RPM intake - dual exhaust - port n polished heads Last year I rebuilt the front end of my carb in order to cure the engine stumbling/hesitation at WOT between 2000-3000 rpms. (relaced gaskets, pwoer valve, float &...