Search results for query: *

A friend of mine was looking to clean out his garage and I scored the 340 long block that was sitting under his bench. The engine only has ~2k miles on a rebuild but I tore into it to see what I had. The pistons are Speed Pro forged L2316's at 0.030 over. They are sitting at zero deck in the...

Over the years we some times get complacent with mundane activities and it came back to bite me today. The Barracuda was due for an oil change and the wife was off to a baby shower so what better time to spend some quality time in the garage. So I changed the oil and filter on the Barracuda...

Anyone have any interest in a set of 5.7l Hemi heads? The dealer my son works at just swaped out a hemi motor in a Ram. The block is junk (number 5 cam through the side) but the heads are OK. I can get them for cheap (likely the scrap aluminum value).

Anyone get Hot Rod (the one with the Cuda on the cover)? The latest issue has an article on a 440 cid (actually 439) small block crate motor that is now being offered by Mopar Perfromance. Siamese bore 4 bolt block with aluminum heads. Supposed to be 525 HP and run on pump gas.

As you all have seen pictures of I built my 360 with magnum heads and I used a Comp Cams XE268H Extreme Energy cam. I also used the stock magnum rockers, MP Mangum R/T springs, the Mopar Performance push rods for the magnum conversion and Melling flat tappet lifters. I broke the cam in at...

Saturday I picked up a piece of 5/16 hex rod so I could prime the oil pump on my magnum headed 360. I have a couple of questions; 1. I put a pressure gauge in the oil sender port next to the distributor and I was only able to get 10 psi with a 1/2" electric drill. Is this to be expected...

Just picked up my block and crank from the machine shop and though you folks would like to see some pictures of the work;