Search results for query: *

Hey everyone i recently did my intake gasket around the middle of march and so far havent had any leaks, its been a few weeks since i last ran the engine because ive been busy and tonight i noticed the intake gasket appeared to be wicking coolant on all four corners but only on the exposed part...

Hey guys, i swear lol if its not one thing its another and at the same time. I have always had a issue every once in awhile with the front pass intake bolt leaking ever so slightly, can hardly notice it and it doesnt do it all the time, i have resealed the bolt once with permatex #2 and it has...

Ok guys well i suppose its time, ran her on sunday and of course the classic industries radiator appears to be leaking at the bottom tank on the drivers side. I guess not too bad for about 8 years old. Not pouring but enough to notice, guess its time to go aluminum. I contacted wizard cooling...

Hey guys, so i will have to replace my leaking milodon water pump and figured while the coolant was all out it i was thinking of swapping out the factory style 22” radiator for a aluminum one, i already have the aluminum shroud from wizard cooling and was looking at getting one of their...

I put a new milodon high flow water pump with milodon t-stat in about 2-3 years ago and i just noticed a few drops of coolant hanging at the weep hole opening after car has been sitting for about 3 weeks while i was working on the brakes. i started and ran it for about 10-15 minutes and No leaks...

That brass bushing that goes in the fan clutch to help center it on the water pump snout is it supposed to be slightly longer than the hole in the clutch itself? I just noticed it while mocking up my aluminum pulleys. The bushing has a split down the length of it but with it sitting in the fan...

whats the difference between the 6 cyl and v8 fan shroud? Will the interchange? I can get my hands on a nos one but i was wondering if it would fit on the 22” rad with 18” blade and v8

i think i already know the answer but is there any tolerable amount of play in the water pump bearing? Just noticed mine has some slight up and down play like if you were checking the wheel bearings. I can barley feel it, but can hear it. Not enough play to see though. Am i looking at replacing...

Any one use the flex a lite fans? Do they actually work? Also ive seen some nylon ones rated to 8,000 rpm. Anyone have any instight or advice

Hey guys i been thinking, are the old fans ok to run higher rpm say 5-6k ? I have a original one on my 340 and just curious, been up to 4k plenty of times and no issues. Think i need to change? If so any recommendations? Im running a fan spacer as well