Search results for query: *

I got my 318 dropped in the 68 barracuda.My Doug's header on the driver side is up against my torsion bar.I started using a truck mount on the driver side.Then tried the passenger car mount.The engine just needs to go over a hair some how.Maybe I can grind the tranny mount holes and push it over...

I am getting ready to install my 318 into my 68 Barracuda.Can I install one or both the Dougs headers before I drop the engine in? Or should I drop the engine most of the way in then bolt up the trans mount.Then bolt the Dougs up while the engine is above the K memeber a few inches?

What do you need to do to replace the starter on a 68 A body with a 318,mini stater,and Doug's headers? Dp you have to pull the header loose?

Are the Mr Gasket Ultra seal header gaskets any good.I have a 318 with stock heads and Doug's headers.Are the gaskets that came with the Doug's and good.Looking for a header gasket that will last as long as possible.

Pulling out the old 318 in my 68 and dropping in a new motor with Doug's.I am thinking pull the old motor with the tranny.And then reinstall the motor and tranny together.Can I drop the engine in with both headers bolted to the engine?I am thinking pulling the passenger side torsion bar or maybe...

What are you guys and Gals sing for header gaskets?I need a set of high quality gaskets.I do not want to replace them in 6 months.I do not see much of a selection for 318-360 gaskets from Summit.I always used a high quality gasket from FelPro on my big blocks.I have the gakets with my Doug's...

Will Doug's headers work with a column shift auto? 318 71 A Body.

I got my new set of Doug's today for my smallblock.Is this dimple or dent usally there?Looks damaged to me.Man I hate sending parts back. Thanks,Jim

Summit brand header for a Duster 273-360 Has anyone purchased and installed these on their A Body.Only $350.00 Summit Racing Metallic Ceramic Coated Headers Silver Ceramic Coated 1 5 8 034 Tubes | eBay

I was going to order a set of Dougs headers for my Duster.Anyone sell them cheaper than Summit Racing? $616.00 Also has anyone used Dougs-D453 Headers and 2.5 Summit exhaust together? Thanks,Jim

This winter or next spring I want to swap the slant 6 out of my 71 Duster with a 318 I have.I will be running a 4 speed transmission.Are there any issues with Dougs headers and a 4 speed? Zbar clearance? What about the starter? Can you pull the start with out any issues? Thanks,Jim

If I relocate my springs will I be able to get the exhaust to come out at the factory location?This would be on a 68-69 Barracuda with the exhaust cutouts on the rear valance.Does the factory exhaust run under the frame rail or along side of it...

Well I said I would let everyone how the Summit 3 inch exhaust fit I ordered a while back.Well with TTi headers and a 383 it Does not fit.Maybe with different headers or on a small block. Does anyone have a 400 or 383 with TTI Headers?Have you used TTI exhaust or Magnaflow?Does it fit and how...