Search results for query: *

Have a friend with a 1949 Plymouth Special Deluxe with a 218 straight six flathead. The car is in need of some carburetor help. I'm not sure if it's a 1-bbl or a 2-bbl unit. He took the car to a restoration shop that "did the best we could". Unfortunately, that wasn't good enough. Is there...

Does anybody know what size bolt/thread will fit this hole?

This is what I have: My buddy thinks I should switch to something like the Mancini Racing set up seen here: What do you have?

My Edelbrock 1406 carburetor is being rebuilt by a friend. Do I need to replace the Edelbrock 9266 Heat Insulator Gasket? This one has been on the engine since August of 2016:

Does anyone have a manufacturer part number for a 14" X 3" air filter. The last one I have was not in its packaging, and I can't remember what brand or part number it was. I went to AutoZone and asked if he could provide search on size and provide a part number. No such luck! Help please!

My Dart GT is finally sporting an Edelbrock LD4B intake manifold and a 1406 600 c.f.m. carburetor and I need an air filter assembly. I got one from a buddy that has a "dropped base" and it does not clear the electric choke on the carburetor. I just want a simple no name chrome lid with a 14"...

What is the proper location for a fuel filter on a '71 318? Between the fuel tank and the fuel pump? Or, between the fuel pump and the carburetor? Which is the better location?

I have an Edelbroack LD4B intake manifold I got off of E-Bay that I have a few questions about (please see photo). #1 What is the hole in the rear of the manifold (between the Chrysler part number and the edelbrock "E") used for? Do I need it? If not, what should I "plug" it with? Would...

Will a fuel filler tube from any year (67-76) Dart (Scamp) interchange? Are the Duster/Demon/Dart Sport fuel filler tubes any different than the Dart/Scamp tube? I believe the tube unscrews from the outside of the quarter panel, then simply pulls out of the rubber grommet in the trunk floor...

Looking through the Classic Industries catalog I've found replacement gas caps. They list: MA8173 - 1967-71 A-BODY FUEL CAP NON VENTED-PRIMER Reproduction fuel cap for 1967-71 Dodge and Plymouth A-Body models. Manufactured as original, this non-vented cap comes primered and ready to paint...

I want to remove and replace the stock 2-bbl carburetor on my '71 Dart GT. I have an Edelbrock LD4B intake manifold, an Edelbrock 1406 600cfm electric choke carburetor, and FelPro intake manifold gaskets (IIRC #1213?). Can I simply transfer/bolt on and use the 2-bbl throttle cable bracket...