Search results for query: *

ok, I am trying to see if I can help get a ball rolling on a group buy of slant to V8 trans/bell housing. THIS IS NOT A SALE POST. just trying to see what interest there is for one. IF there is enough, Then I can post a for sale post. ( cant start a sale post without pictures or a price - or I...

alright, I am going to try my best to document my re-build it was a 225 with a Aussie Hurricane intake, Clifford Header & FiTech. started tearing it down to re wire the entire car, upgrade the charging system, switch over to multiport injection and coil near plug ignition. figured it would be...

I am looking into a turbo build for my slant. would there be any benefit or drawback to the dutra manifolds vs a custom header? was thinking the manifolds would be a little easier to plumb up vs making a whole header. possibly less likely to leak as well. thanks!

ok, with all the rocker talk lately. it has me wondering if, I did put a set of 1.6's in my slant. would I have enough valve clearance? cam is currently a 465 lift, would end up 496 with a 1.6 rocker. head was only given a slight shave, block on the other hand was given a bigger cut. we cut...

ok, I have been mulling over fuel injecting my slant. fighting this 450 Holley is pushing my limits. just want to enjoy the car. ( I did add a wideband to try helping, just need to wire it up) looking at the FiTech ( with the power adder option for later ) have considered getting a rail and set...

ok, since I know that my cracked block wont last forever glued together. I am looking for direction on rebuilding the spare. don't want to go broke rebuilding it so the pricey rod/piston combo are out. mostly a cruiser for the street. is a re-bore with stock style replacement pistons and...

ok, I have a 450 holley ( mech secondary ) on my 225. the short block is a re-ring/bearing with .120 milled off the block, little .465 lift erson cam w/222 [email protected], ported head with 1.70/1.44 valves. Aussie intake & Clifford headers, scavenger y into 3" exhaust. 904 trans w/2800-300- stall &...

ok, so I don't know how it was missed during the clean up/re-ring. but yesterday while prepping for the replacement intake gasket to show up. we were checking for coolant leaks ( had a intake/exhaust stud leaking ). found a 1-2" crack in the block just above the pan rail. my daughter was...

ok, so I'm finally going to build a slant. Have wanted to and started once before but, life got in the way. I have a ported head with oversized valves, performance cam( don't remember the spec's ),hurricane intake, header. Now the questions begin. I have a later cast crank block ( milled .120 )...

does anyone know who makes an early A slant six header?

Is there anyone out there making replacement rockers for the slant? not looking for a Roller or anything fancy just a Quailty replacement Thanks,

ok, we are looking for some help with selecting a Turbo for our slant. here is what we have and what we are thinking. re ringed slant short block (milled .110 kid had it milled before we went turbo) erson 265 dur cam. ported head , aussie intake. we are thinking a low boost (8 to 15psi) with...

where can you get a good cam for the slant, i have a couple emails in to erson, the comp cam selection is a lot smaller then we r looking to run Thanks

ok we are building a slant for my old dart for my son. this is what we have so far . slant head w/oversize SI valves being ported and polished he wants to run the Ausie Speed intake possibly there headers too (unless we come across a used set) for now we are using a cast crank low mile...