Search results for query: *

  1. wheelz 63 dart gt

    Timing, carb, and cooling trouble

    So I finally got the dart running. My Carb spits fuel up at me with the air cleaner off., I can not seem to get her below 10 degrees tdc.I cant turn the dizzy any farther. The mark on my balancer may not be right,or i am a tooth off when i set the dizzy in. When I put the light on her she seems...
  2. wheelz 63 dart gt

    Lower intake manifold cracked.

    I can not believe how dishonest people can be when u buy a car. I was told that my engine was rebuilt with only about 5000 miles on her. The gaskets did look new but i still wanted to pull the motor and make sure things were done right. I cant believe this s#*t I am finding. Missing bolts and...
  3. wheelz 63 dart gt

    Pullin the /6 out with tranny?

    I WANT TO PULL MY /6 OUT WITH MY TRANSMISSION. CAN I PULL THEM OUT TOGETHER OR DO I HAVETO DISCONNECT THE PUSHBUTTON TRANSMISSION DROP IY, AND THEN PULL THE ENGINE? I WANT TO PULL THEM OUT TOGETHER AND GET MY BAY ALL CLEANED AND PAINTED. cAN SOME ONEONE TELL ME THE EASIEST , AND MOST LOGICAL...
  4. wheelz 63 dart gt

    Timing Mark on Cam Gear 180* off

    I tried to set the timing at tdc. I took my timing cover off and took out all the plugs, and put my compression tester in #1. I turned her over by and and every time i built up compression I would look at my marks and my crank gear mark was in the right spot , but my cam gear mark was exactly...
  5. wheelz 63 dart gt

    63 gt still wont start

    I got my new balancer, and slid it on. I put her on tdc and with the key on i turn the distributor just slightly until i hear a little pop inside. then i try to fire her up. I do not think shes getting fuel, or my distributor is still off a little. I may need to take the fuel pump off and give...
  6. wheelz 63 dart gt

    My Haronic Balancer has a small crack

    My Harmonic balancer has a small crack where the key slides in. Can it be saved. Can jb weld preserve it temporarily? A brand new one from Napa is 300 bucks! Damnit!
  7. wheelz 63 dart gt

    Mopar VIN decoder does not decode 1963

    I tried the mopar VIN decoder but I can not do my 1963 dodge dart gt on there. Here is my vin 7435131592 Engine id is 12 27 above engine id 2463430-5...
  8. wheelz 63 dart gt

    Where does this plug into.

    I can not find a home for this wire. It is in the same harness as my coil wire, and temp gauge wire.
  9. wheelz 63 dart gt

    No timing tab

    So my timing cover is missing its timing tab. I took the timing civer off, and lined up the crank and cam dots while on tdc of my compression stroke. I then placed my distributor in pointing at # 1 . How do i know where to set my distributor with out being able to start it and hit it with my...
  10. wheelz 63 dart gt

    What is this part

    This connects to my transmission pan. Can some one tell me what is is and where does the other end go
  11. wheelz 63 dart gt

    I got the 6 to turn by hand!!!

    I got that bolt that Johnny Dart recommended, squirted some wd 40 into the cylinders which im sure were very dry and worked the crank shaft back and forth until it became easier. Like i said i took over some ones un finished project which can be very scary sometimes. you never know what you are...
  12. wheelz 63 dart gt

    cant wrench the 6 by hand

    I wanted to put my new 63 gt at top dead center to time her. She does not run yet. I can bump her over with the key, but i cant turn the crankshaft pulley by hand. Yes all the plugs are out. I do not under stand it. Can some one help. my transmission is in neutral, but my parking lever cable is...
Back
Top