Search results for query: *

Final step in rewiring entire car .... can someone confirm this relay setup for a Choke. Please dont give me any other ways as I want to run a relay and want the choke dead in acc. and not heating up. Cannot do the oil pressure set up. Thanks guys

Where can I tap in the choke wire under the dash. I was thinking to splice it in the cig.lighter wire but can both work at the same time. Or would splicing into the radio wire .... was worried it may cause static in the radio or noise. Any other suggestions would be great as long as it connects...

Need so help ....I had a custom Dash made by one of our members so now I'm taking the old gauge panel and inserting the new one with autometer gauges. The old wiring has two 5-pin connectors for dash gauges and turn lights. I think I can show it better below. Look at *** 1st - 5-pin Connector...

Do not remember which wire goes on which terminal. If anyone has a pic of a 69 dodge dart showing a close up of the 2 wires for the washer motor ..... not sure which one is the terminal for the ground and nothing marked on the or by the terminals.

69 Dart, 360 fuel injected, auto. Hey guys, loosing it here, cannot figure this out. Late last fall, Car started and went for a ride. Got about 2 miles and it died as I was coming to a complete stop. Turns over but would not start. Fuel pressure was fine and checked coil power ....no power to...

Working on cleaning up the wiring in the engine bay. I wanted to run the alternator wiring direct to starter relay with a circuit breaker with reset, bypass the amp meter, clean up connections there and run wiring to some sort of fusable distributon block. i also have a small underdash amp that...

What gauge wire would you recommend for a powermaster 75 amp unit with external regulator. I seen 10 gauge on mads site but also was told you should run a 8 gauge. Also do you have any recommendations on a fuse holder and a part number that would work with it and should it be mounted just before...

Hey guys ..need some help wiring the engine bay .... I have a 69 dart but picked up a new harness ... everything seems right and is set up for a electronic ignition. The new ready to run msd dizzy does not require a external box and the ballast resister should not be used. Questions are ... I...

Does anyone have a pic of there voltage regulator mounted on a 69 dart that is stock. Mine has been relocated and the pics I have seen have them mounted in several different locations. Just need to see where they were located from the factory. Thanks

Has anyone here been able to find a 60-65 amp black alternator in a 3-wire - external voltage regulator ....any help would be appreciated ..... so far I can only find a 100 amp 3-wire in a tuff stuff brand.

Just ordered a new wiper motor for a 69 dart and rec'd one that does not look like my old one. The new one has the motor coming toward the front of the car and the one that I have goes towards the drivers side. Does anyone one now which is the correct one. Also ... the new one says no washer...