Search results for query: *

Need to order plug wires for my new small block that is going to have TTI step headers. Will straight boots work ok or do I need a different shape? Thanks for any help.

My engine went from running well to progressiveIy running worse and now not running. I have a Pertronix ignitor ignition system. I am getting intermittent spark at the plugs when I ground them. With the key on in "run" and grounding a plug on the exhaust manifold I get an intermittent spark...

My dart has no spark coming from the coil wire. My car has the original wiring harness with a Pertronix ignitor 1 ignition conversion. The ballast resistor wires have been soldered together so the ballast resistor is bypassed per instructions by Pertronix. Car ran great until recently. Found a...

Can anyone tell me if a GM hei ignition module has to be grounded to work? Using it with a mopar electronic distributor on a 67 dart. Thanks.

Fired up rebuilt 318 for break in. oil pump primed, carb fuel bowls filled, timing set. Using pertronix ignition conversion that worked on previous engine. Ballast resistor replaced with wire per instructions. Engine turned over a couple of times and fired right up. Ran to 2000 rpm for cam...

Had to replace my alternator with a rebuilt one. Before installing it can I paint the outside with some rattlecan clear to help keep it from oxidizing like the old one did? Would overspray in the exposed inside parts hurt anything? Looks like the exposed windings are already coated with something.

I have an old school remote starter for turning the engine over while you are under the hood. I don't remember how to hook it up. Can someone help? Thanks.

Can I use the starter relay stud for a power source for my electric choke and tach power wire? Tried to run a brass tap off fuse box but can't get taps and fuse back in the clips. Is relay hot all the time or just when ignition switch is on?

I am adding an aftermarket tach to my car that did not have one from the factory. I am not knowlegable about wiring. The wire to the coil and the ground wire I can handle. Looks like I need a 12v switched ignition source and another wire to light switch for the internal tach illumination (not...

I am reconnecting my engine bay wiring harness after replacing my engine and forgot to label a couple of wires. Does the wire with tbe ring connector by the fan motor bolt to one of the fan motor studs? Where does the brown wire go? It exits the main harness with the white wire that goes the...

I saw an old thread on fbbo about Ted's mopar wiper motor restoration while looking around for info on wiper motor restorers. Looked like he had good prices although don't know if they are current. Has anyone used him or used anyone else recently that was good and reasonable? I know those are...