Search results for query: *

As stated in the title, looking for a 30 spline 833 short main shaft. Thank you! Dave

As per the title. Looking for a small block scattershield set with the front plate and starter index. Thanks! Dave

Looking for a tailhousing and corresponding main shaft 26 or 30 spline, A/F body. Preferably 30 spline, but I am open to 26. I also need at least one 30 spline output yoke from a driveshaft, possibly two, depending on what I end up with for the main shaft and tailhousing. Also looking for...

Hello. I fear that my stone shields may have hit the scrap yard. Had some stuff stored in a garage while I moved, went up there to pick up my 4x8 aluminum diamond plate sheet and some car parts only to find out that they were weaseled in with some of the junk that they were getting rid of, on...

Just like the title says. Looking for an NP A-833 4 speed 3/4 synchronizer sleeve with 3/8" wide keyways. These were used on 1970 up units. Thanks!

Just like the title reads. I'm after a 5.125" or 4.807" index small block bellhousing. I have a 4.354" bell and a 4.160 bolt circle on the case. I can make it happen if I have to, welding up the fork pivot holes and repositioning them to clear cutting the bell to a 4.807" hole, but I'd rather...

I am looking for a couple of hard parts to complete my project 4spd. Some of these parts I may end up getting from Brewers or elsewhere, but I thought I'd try and give my money to someone here, first. I'm looking for the following stuff, if you've got it, all or some. - A/F body 12" tailshaft...

Hello. I'm looking for the left side/ driver's door glass without tint, for a hardtop. The glass will be going in a '63 Signet, without A/C. The 2door post has different glass and I'm not sure, but I think the roof line on the Barracuda calls for different glass as well. Thanks! Dave

Hello, FABO. I'm after a few hard parts for my transmission project. Local swap meet today didn't turn much out for me, so I'd like to give my unused money to those here looking to move unused parts before going other places. I'm working on a 23 spline input, 4.8" index bearing retainer short...

I've got a bell for a 4.807" bearing retainer. I can use the small bolt pattern iron case as well, but would prefer the larger front bolt pattern case (4.16" bolt circle), but anything iron is ok by me, 307 or 308 bearing, cobwebs, reverse gear, breather, drain plug or none, rust or whatever...

Hi folks! I'm looking for a rear left or right retractable seatbelt in black (came in lots of color combination interiors) for a '72 '73 '74 A body. They look like this - I only need one retractor and female counterpart, but I'm open to whatever. Let me know if you have anything...