Search results for query: *

So I pulled the pumpkin on my 8 3/4 to replace gasket and pinion seal. These parts were sitting in the housing. I think they are used to set end play on the axle. When I put it back in the ball bearing doesn't touch the axle. What i'm I missing? Who's Posi unit, uses this set-up so I can get...

OK! I bought the book ,and a have factory repair manual. Took all the measurements while disassembling, cleaned, replaced seals and thrust washers and started to assemble. Reduced the end play down on the gear train. Input end play was at .069". When I assembled I had .105"?????? So I...

Planning on rebuilding my 68/727 transmission stock rebuild. Does anyone have a good recommendation on where to buy a Master rebuild kit . I use to buy from Sentinel Transmission but they were bought out and I can not remember who bought them out. Thanks Mark