Location - Southeastern Connecticut.
8 pistons for a 273 engine
These are .030” over sized with rings, wrist pins and clips. Very clean and hardly used.
I sent this 273 to the machine shop I bought from a 66 Barracuda 2bbl car I bought with just over 250miles since a rebuild (rebuild was over 10 years ago). Machine shop told me to not to chuck the pistons since these were so clean. These measure 3.655” (I’m no machinist but I think I got it right.)
$150 plus shipping. Skirts are very clean and wrist pins are floating and also look really clean. There is some staining on 2 piston tops that the machine shop said was normal. These would be great for a standard rebuild 273 needing a bore increase. These is a stamp on the top that shows P275 and a cast in number inside the skirt 322NP other than that I can try to answer any questions but unsure of manufacture. I accept CC over the phone, vendmo, check or cash.
Syleng1
8 pistons for a 273 engine
These are .030” over sized with rings, wrist pins and clips. Very clean and hardly used.
I sent this 273 to the machine shop I bought from a 66 Barracuda 2bbl car I bought with just over 250miles since a rebuild (rebuild was over 10 years ago). Machine shop told me to not to chuck the pistons since these were so clean. These measure 3.655” (I’m no machinist but I think I got it right.)
$150 plus shipping. Skirts are very clean and wrist pins are floating and also look really clean. There is some staining on 2 piston tops that the machine shop said was normal. These would be great for a standard rebuild 273 needing a bore increase. These is a stamp on the top that shows P275 and a cast in number inside the skirt 322NP other than that I can try to answer any questions but unsure of manufacture. I accept CC over the phone, vendmo, check or cash.
Syleng1
