04 5.7 hemi with 2010 5.7 eagle head question

[tblotske]

how big a cam could I run with this on stock bottom end and any ideas on hp it would put out

 

[mcat]

what head gaskets are you going to use? a .075 is required to get the compression ratio down to a bout 11-1 and with that gasket, you can go fairly large on lift

 

[tblotske]

just the factory gasket im going to run a carb and e85 fuel

 

[mcat]

i would suggest calling a vender that is familiar with that setup maybe inertia or hhp

 

[twayne24365]

i would suggest calling a vender that is familiar with that setup maybe inertia or hhp

x2, im interested in the numbers myself

 

[kurupt17]

just the factory gasket im going to run a carb and e85 fuel

This is awesome. I plan on running a forged stroker 392 with the eagle heads on e85. If I recall the compression will be around 12.5:1. I am almost postive you will need a custom cam to make it work. I have a few cam specs laying around some where, but they are based on my stroker and not a stock engine.