[Found!] 1406 Eddy

[4spdragtop]

Doesnt have to be new, used is fine. Shipped to Ontario Canada
Thanks
Steve

 

[4mulas]

I have one. Message sent

 

[AlaskaJeff]

I've got one too. PM sent if 4mulas doesn't work out

 

[CFD244]

Ah Crap...........

 

[4spdragtop]

Yeah, I've been toiling over the damn thing a few days now, my own fn stupidity.
I have tried damn near every type of extractor lol. Theres still brass there, I may still get lucky?

Ah Crap...........

 

[halfafish]

Let me know if the other guys can't help. I think I have one squirreled away somewhere.

 

[oldkimmer]

Yeah, I've been toiling over the damn thing a few days now, my own fn stupidity.
I have tried damn near every type of extractor lol. Theres still brass there, I may still get lucky?


View attachment 1716075633

View attachment 1716075634

Depends on the wifey. Kim

 

[NoCar340]

Yeah, I've been toiling over the damn thing a few days now, my own fn stupidity.
I have tried damn near every type of extractor lol. Theres still brass there, I may still get lucky?


View attachment 1716075633

View attachment 1716075634

Carefully heat that area with a propane torch, and apply beeswax--pure beeswax like they sell in blocks at craft shows for candlemaking. If the wax smokes or bubbles, you're overdoing the heat; you want it just warm enough to melt the wax and not much more. Think of this like sweating a copper pipe--you want the wax to work its way in. If you successfully wax it, it should come out with an easy-out.

It's a bit tricky, but once you get the hang of it it's a godsend in salt country.

 

[Capt46]

Or try soldering gun heat to pin point a bit better

 

[MOPAROFFICIAL]

Take it out back and shoot it. Lol
Might just try a torch... brass just blows out.

 

[4spdragtop]

Thanks Bill, CFD244 mentioned that trick. I tried that, no luck lol. I have one coming.