[WANTED] 1964 cuda body parts needed

[guido]

I am looking for the following passenger side parts for my 1964 cuda
some ding bat girl T-boned me after running a stop sign.
1. the door,
2. the front fender,
3. wheel well
4. Rocker Panel stainless steel sill plate
5. complete cut...a pillar and rocker panel
See Picture for the damage
Perhaps info on junk yards that might have them.
Thanks Angelo aka Guido

 

[Lee Robinson]

I am looking for the following passenger side parts for my 1964 cuda
some ding bat girl T-boned me after running a stop sign.
1. the door,
2. the front fender,
3. wheel well
4. Rocker Panel stainless steel sill plate
5. complete cut...a pillar and rocker panel
See Picture for the damage
Perhaps info on junk yards that might have them.
Thanks Angelo aka GuidoView attachment 1715974918

For the wheel well are your referring to front right inner fender apron? I most likely have it. I have a right rocker/front door pillar from a Valiant
which is the same as Barracuda. It could be sectioned in the rocker but shipping would be a lot as I'm in Ca.

 

[guido]

I believe so, but i need to pass the parts by the body shop 7743121990

 

[Lee Robinson]

I believe so, but i need to pass the parts by the body shop 7743121990

guido, here are some pics of the parts I have. Fender apron, door hinge pillar/rocker panel. It's from a 4 door but it looks like you only
need a section of the rocker panel. Door is 66 Valiant so it has those trim holes on bottom. All other hardtop doors I have are 64 and
65-66 Dart GT doors which have a lot of different trim holes than Barracuda.

 

[halfafish]

I have a very good passenger door, windows works fine, no dents, fully loaded. It does not have the door card or armrest. I'm asking $200 but shipping would be unpleasant, I'm in Washington. PM me if you'd like to pursue this. Sorry about the crappy picture, it is in the trunk of a parts car and it's the only photo I have on my phone.

 

[sunroof360]

I think I have a passenger side front wheel opening trim moulding? are you needing one, please pm me back

 

[sunroof360]

I have one but shipping from arkansas is going to be pricey, I would take 50 plus shipping. I will hold this one for you, maybe you can find one local. My part is average shape, the worst part is some of the mounting holes are sunk in a little, I will try and get better pics , next few days