1967 barracuda wheel lip question

[fireguyfire]

My 67 barracuda fastback is an unrestored car, and is really solid except for 2 rotten spots; 1 in front of and 1 behind the bottom of the drivers side wheel well.
I’ve made tons of repair panels over the years and these will be easy, but I had a question. There is a body line that goes around the wheel opening to the rocket trim. Does this body line go right to the bottom of the car, or does it fade out at the bottom so that it is flat where the stainless rocker trim goes across it and meets the wheel lip moulding?

Perhaps someone could post a photo of this area for me?

 

[A56]

My 67 barracuda fastback is an unrestored car, and is really solid except for 2 rotten spots; 1 in front of and 1 behind the bottom of the drivers side wheel well.
I’ve made tons of repair panels over the years and these will be easy, but I had a question. There is a body line that goes around the wheel opening to the rocket trim. Does this body line go right to the bottom of the car, or does it fade out at the bottom so that it is flat where the stainless rocker trim goes across it and meets the wheel lip moulding?

Perhaps someone could post a photo of this area for me?

What does the passenger side look like?

 

[dadsbee]

Wife's 3700 mile Formula S (ignore the 68 stripe). Gradually fades out. Totally gone about 4.75" up from bottom of rocker. Hard to photograph....

 

[fireguyfire]

Perfect, thanks dadsbee. I figured that line faded out towards the bottom.
The passenger side is similar but not as bad.