1968 Dodge Dart Western Sport Special Restoration

-
Had to remove the shackle brackets that were welded to the frame rails so the leaf spring slider brackets would fit in and go all the way back. I cut the brackets out and ground off the welds.

IMG_4532.jpeg


IMG_4534.jpeg


IMG_4533.jpeg


IMG_4531.jpeg
 
I had to remove the leaf spring shackles relocation brackets from the frame. Cut them out and ground the welds down. Did this so the leaf spring slider brackets would mount all the way back against the stock out board mounts.

IMG_4534.jpeg


IMG_4533.jpeg


IMG_4532.jpeg


IMG_4531.jpeg
 
This weekend I took down the passenger side rear 1/4 panel to bare metal, had less holes drilled in it but much thicker body filler then the drivers side also had a patch panel made in the rear lower section. I wanted to see if that can be replaced with a new piece and remove the piece that was made there. Has some open weld seams.

IMG_4556.jpeg


IMG_4559.jpeg


IMG_4558.jpeg


IMG_4557.jpeg
 
Took my HDK Hemi Denny front suspension pieces to a local powder coating place and had them done in an espresso brown with a brass flakes. It came out great, I will post pictures of the k member and loop bars next

IMG_4635.jpeg


IMG_4640.jpeg


IMG_4641.jpeg


IMG_4767.jpeg


IMG_4768.jpeg


IMG_4769.jpeg


IMG_4770.jpeg


IMG_4771.jpeg
 
I had the rear bumper brackets done a while back and the bumper chromed by the guy at spring fling about 4 years ago. Getting it ready to mount on the Dart

IMG_4654.jpeg


IMG_4653.jpeg


IMG_4652.jpeg


IMG_4651.jpeg


IMG_4656.jpeg


IMG_4650.jpeg


IMG_4655.jpeg


IMG_4657.jpeg


IMG_4658.jpeg
 
You must log in or register to reply here.
-

Back
Top