273 Build

-
A 861 Power Pack option. That's what it is!
I have had a few of you ask me to keep up on my 273 build. I have butted in other peoples threads from time to time with comments and a photo or two. It's time start from the beginning with the story and photos. I am far from done at this point. The heads are near finished and I have lots of clean up and bead blasting to do. I hope to clean my garage this weekend and possibly begin work on the short block. (frost plugs, oil galley plugs, etc) Then comes the crank and pistons and rods as time allows. Oops, I'm getting ahead of myself.

Last fall I pulled the drive train and began disassembling and cleaning. I didn't know what a gungy mess everything was until it was out of the car in the daylight. A lot of scraping,engine degreaser and a trip to the car wash got the most of it. When I took things apart I was surprised to find 2 different casting #
heads. One was an original 66 head and the other was a 67 head and one of the rods had a 12/72 stamped bearing set. A little oops got fixed in 1973 apparently.

View attachment 138856

View attachment 138857

View attachment 138858

View attachment 138859

View attachment 138860
 
Yes? You quoted me but you didn't respond.
 
@toolmanmike It's hard to believe that you started the work on your car over 14 years ago. Damn, time flies when you are having fun!
That is true. It still runs good and is a fun car to drive. I better change those plugs next spring! LOL
 
Old tread but thanks so much it was a joy to read threw , how great is it to see all the steps and all the joy it brought to everyone watching , you should be proud : family , job and still the passion to build such a great sounding rig . Im sure its a fun ride.
Nice ride
 
-
Back
Top