[WANTED] 3 Groove crank pulley for cast iron water pump small block

-
Status
Not open for further replies.

BergmanAutoCraft

FABO Vendor
FABO Vendor
Joined
Feb 18, 2013
Messages
545
Reaction score
569
Location
Hampstead, NC
Rating - 100%
1   0   0
Contact seller
As the title says. The cast iron water pump small blocks (up to 69) are not the same as later 70 and LA small blocks. I'm looking for a 3 groove crank pulley for an AC small block.

PM me with what you have.
 
I have this one.

Came off a 68 or 69 318 with cast iron water pump.

The engine was not original to the 67 dart but the car had AC and Power Steering. The idler was present on the engine


It most likely has sat in TX or CO (high desert) since 1976

The pulleys measure:

I took tape and ran it around the pulley outer dia then made a mark, measured the length (circumference) and converted that to dia

Inner 6.2" dia
Middle 6.6" dia
Outer 7.87" dia

Depth, face down on a table, is 3-13/16 outside to outside.

The rubber isolator pretty but it is soft.

It is how I pulled it off, I have not done anything to it, not even washed it.

$50.00 plus shipping (obo)

PXL_20241003_161843433.jpg
PXL_20241003_161852700.jpg
PXL_20241003_161902980.jpg
PXL_20241003_163112661.jpg


PXL_20241003_163139849.jpg
 
As the title says. The cast iron water pump small blocks (up to 69) are not the same as later 70 and LA small blocks. I'm looking for a 3 groove crank pulley for an AC small block.

PM me with what you have.
I have a set on e-bay alt. & p/s the a/c pulley is separate check it out item# is 387314979878 let me know if that is what you can use
Joe
 
Status
Not open for further replies.
-
Back
Top