340 or 360

-
Status
Not open for further replies.
You should put in a location Dan. That can help speed things up.
 
I have a freshly rebuilt 1970 340. Just needs an intake, carb and distrib. It's never been off the engine stand since I built it a couple of months ago. I can give you more pics and information about it if you're interested. I have it listed on the Moparts.com site in the May section of the small block parts for sale. 2nd page, screen name is physixx. Martinsburg, WV is only about 4 hours away so it's not that bad. I can even meet you part way. I'm asking $2700.00 plus shipping if you wanted it shipped. Let me know.

Ken
Edison, NJ
[email protected]

image0003.jpg
 
360 shortblock, bored .020 over, rebuilt rods, Speed-Pro hyper pistons, block decked to 9.6 inches, fresh rings and bearings, cast crank, balanced to B&M flexplate and summit balancer (the $240 one) for use with neutral balanced converter, $1250 plus shipping. I can also bolt on some ported 587 j-heads that were rebuilt for extra. Located near Portland, OR Let me know by email [email protected]
 
Hi do you still have 340? How are you asking? I live in London ontario
 
If your asking about the 340 pictured above, I sold it, but I have a 360 that I'm freshening up for a friend of mine. All new parts. He wiped out a cam with only a few minutes on the engine due to not correctly doing a break-in procedure with the correct oil. If you're interested, I can get you more information and some pics.

Ken
Edsion, NJ
[email protected]
 
Status
Not open for further replies.
-

Back
Top