[WANTED] 360 LA centersump oilpan and pickup

[diymirage]

hey guys
i bought a 360 to put in the duster but it has the rearsump truck pan on it
i was hoping someone has a nice used centersump and pick up before i spend a ton on a new one
i would need it shipped to Holland MI 49424

thanks guys

 

[red_srt10]

PM sent....

 

[diymirage]

PM replied, still looking

 

[Abodybomber]

PM replied, still looking

Might send WHITEPUNKONNITRO, a P.M......

 

[diymirage]

thanks for the tip, i just PMed him

 

[krazykuda]

You can buy brand new pick-up tubes at NAPA for about $20

 

[jferrel]

Summit has a $49 pan, can't remember what the pickup tube cost me, along with cheap but good - milodon one piece gaskets with the washers molded in.... soooo much nicer than working with old stuff that is the same price.
...and that's coming from a cheap guy like me!!!

 

[d5667]

Like the cheap guy said;I have pans but for 50 bucks,buy new.

 

[diymirage]

Summit has a $49 pan, can't remember what the pickup tube cost me, along with cheap but good - milodon one piece gaskets with the washers molded in.... soooo much nicer than working with old stuff that is the same price.
...and that's coming from a cheap guy like me!!!

New it is, thanks for all the replies guys.

Now, what is this about a single piece gasket?
And will it work on my 75 LA engine?

 

[scooby67]

http://www.ebay.com/itm/SB-MOPAR-36...Parts_Accessories&hash=item1e9157cf38&vxp=mtr

 

[jferrel]

Yes to the question about the LA engine....

Here is the oil pan:
http://www.summitracing.com/parts/sum-g3536/overview/

I want to say this is the right pickup tube:
http://www.summitracing.com/parts/mel-72-s4/overview/

NOTE: the mel-72-s5 is for the truck pan... If Napa has it cheaper go there... its a tube!

The gasket I like ($36 versus $20ish):
http://www.summitracing.com/parts/mil-41007/overview/make/dodge
Sooooo... worth it!

 

[69413valiant]

Do you know if that pan will work on a 66 dart?

 

[jferrel]

It's the exact dimensions of a stock 360 car pan.
I can't say "I've put a pre-magnum 360 in a 66Dart" -- but if I were to try, that's about the only center sump pan you can get without going with a high volume pan... so I don't know why it wouldn't.
I build stock 360's, and 360's into strokers for most of my darts and dusters (72-74). The only thing you would face different than what I face is that I am using the spool mount K-members.
My 65 Barracuda has the pad mounts with a 273. It came with two set of engine mounts, one set was an inch thicker than the ones I'm running, but bolted in the same.... so I know you can lift the motor up if the pan hits.