360 parts needed

[discharger1332]

so i picked up a 67 valiant a while back and just realized the 360 is using 273 motor mounts. so i need to find some motor mounts that will work. any ideas what model will have correct mounts? i think its a '78 360 block. also looking for a rpm or air gap intake? thanx for any help.
cheers

 

[discharger1332]

any ideas guys?

 

[Mr Hemi]

http://www.carcraft.com/techarticles/116_0111_transmission_swap/index.html

 

[Mr Hemi]

I build a spacer for mine and welded on one tab

 

[cudamark]

Usually, you have to modify some 318 brackets or buy them from Schumacher.

 

[discharger1332]

i had a feeling that was the case thanx guys

 

[discharger1332]

was just looking again, my mount has the single hole lower. reather than high like the ear on my block. so i need a diferent mount

 

[highflyer]

iv got mounts for the 318 buiscuit and roll type..rear trans mt and

 

[JBurch]

I think 340 engine brackets will work for you; 360 has the same block lugs.

 

[oldkimmer]

................U need a 68-72 A body drivers side mount....pass is the same.............kim.........

 

[discharger1332]

ok thanx for the help guys. does anyone have one theyre willing to part with?