4 speed console carpet hump

[OnEbAd340]

Does anyone know if there is someone or a place that sells repro fiber board or fiberglass humps for the 4 speed console (1969)?

I never had the original fiberboard as it was long gone. Any help would be appreciated!

 

[Murray]

I have only seen people that make their own. Good luck.

 

[Bigboy 68]

@waggin. He Repops them

 

[OnEbAd340]

@waggin. He Repops them

Thank you, sent him a message inquiring about it.

 

[OnEbAd340]

I have only seen people that make their own. Good luck.

Thanks if I cant find it, I guess I'll make one and try to have it 3d printed.

 

[cudarudy]

Thanks if I cant find it, I guess I'll make one and try to have it 3d printed.

don't think you need one if using a hurst shifter.

 

[OnEbAd340]

don't think you need one if using a hurst shifter.

I have the cutout on the console so when tring to carpet it, the carpet in that gap has nothing to be glued onto. My car is a factory console car, this is the orig console with the factory hurst shifter

 

[OnEbAd340]

 

[waggin]

Thanks if I cant find it, I guess I'll make one and try to have it 3d printed.

i have a couple of them already made out of fiberglass, I left a large flange to trim down as desired 50$ shipped

 

[4spdragtop]

Nice work Curtis!

i have a couple of them already made out of fiberglass, I left a large flange to trim down as desired 50$ shipped

View attachment 1715524306

View attachment 1715524307

View attachment 1715524308

 

[Murray]

Would it be easier to make these on a 3D printer?

 

[waggin]

Would it be easier to make these on a 3D printer?

I'm not familiar with the printer deal but the fiberglass is very flexible and will hold up to vibration

 

[waggin]

in the pictures from left to right the first one is the mold for 65 barracuda, second one is 67 and up then the console hump and a finished ready to install 65 four speed hump, 66 is diffrent so i dont have an original to make one

 

[moparchris340]

i have a couple of them already made out of fiberglass, I left a large flange to trim down as desired 50$ shipped

View attachment 1715524306

View attachment 1715524307

View attachment 1715524308

By chance do u still have any of these? Thx

 

[waggin]

By chance do u still have any of these? Thx

what is the car you need it for?

 

[moparchris340]

what is the car you need it for?

68 Dart

 

[waggin]

it will take me a week or so to find them as i am unpacking

 

[Demonracer]

Wags, good to see you back on FABO. I hope all is going well with you.

 

[moparchris340]

it will take me a week or so to find them as i am unpacking

Ok thank you

 

[thomasjkt]

You have anymore of the 68/69