[SOLD] 440 Block Fresh Machined

[chargerjoe68]

78 Cast 440 Block has been bored .030 over
Sonic cleaned new brass freeze plugs and cam bearings installed. Ready for assembly
Forged steel Crank is 10/10 and ready to go.
LY rods reconditioned with ARP bolts and has full floating pins. I don’t have pistons!
I will sell block rods or crank all separate!
$2000 OBO
Located in East Palestine Ohio

View attachment 1715868308

View attachment 1715868309

 

[Oldmanmopar]

Looks like those pistons were run in a motor upside down at one time and then re fly cut after turned around. You should mention that. Means a lot on needing a fresh power hone to resize for new pistons. Also rebalance will be needed. Honesty makes a big difference on the sale of items on this site .

 

[jdsduster]

Looks like those pistons were run in a motor upside down at one time and then re fly cut after turned around. You should mention that. Means a lot on needing a fresh power hone to resize for new pistons. Also rebalance will be needed. Honesty makes a big difference on the sale of items on this site .

what does that mean run upside down? re-fly cut?

 

[Oldmanmopar]

what does that mean run upside down? re-fly cut?

You can see where the valves hit the pistons when they were installed facing the wrong direction. The little dents from the valves opposite of the flycuts? I should have said 180 degrees off instead of upside down. Sorry about that.

 

[chargerjoe68]

You can see where the valves hit the pistons when they were installed facing the wrong direction. The little dents from the valves opposite of the flycuts? I should have said 180 degrees off instead of upside down. Sorry about that.

The pistons where not installed in that block. That block has never had anything installed
I was just offering the rotating assembly with the block.

 

[jdsduster]

You can see where the valves hit the pistons when they were installed facing the wrong direction. The little dents from the valves opposite of the flycuts? I should have said 180 degrees off instead of upside down. Sorry about that.

ok , now i see,

 

[chargerjoe68]

$1600 OBO Rods are sold
Block only $1200 OBO
Crank only $400 OBO

 

[oldkimmer]

Pistons? Kim

 

[chargerjoe68]

Pistons? Kim

Block and crank only. I will seperate

 

[chargerjoe68]

Crank Sold
Block Only Left $1300 OBO