[SOLD] 512 Mopar Motor and Tranny

-
Status
Not open for further replies.
C

countrygirl

Member
Joined
Jul 5, 2014
Messages
19
Reaction score
0
Location
Maryland
Rating - 0%
0   0   0
Contact seller
512 Mopar motor (Stroker kit from 440 source), 440 source crank, new rods and pistons. Bored and hone with torque plate .030. Compression is believed to be 10 to 1. 10/50 Dominator with 4500 stall converter tranny. Asking $6,000.

This motor was built by my husband and has very little run time. This motor was in a 64 Plymouth Belvedere. I would like to see this motor and tranny go to someone who loves Mopar's as much as he did.
 
On the side of the block you will see a series of numbers. Some on each sidewall. Front of motor is a flat plate, numbers and letters there too. Someone is bound to ask. Glws
 
The numbers on the front of the motor are 440 B 7 26. On the side the number is 2536430.8 if I am reading it right. Let me know if you need anything else. Thank you.
 
New information, that might be helpful the cam is a solid lifter and the intake is an Edelbrock. Car ran in low 12s and only went down the track a few times, might have 100 miles on it. This motor has the ability to go much faster.
 
countrygirl said:
New information, that might be helpful the cam is a solid lifter and the intake is an Edelbrock. Car ran in low 12s and only went down the track a few times, might have 100 miles on it. This motor has the ability to go much faster.
Click to expand...

Was that on street tires or slicks and what gears in the rear?
 
New information motor has been hand turned, everything moves and built compression. She is just waiting to spin the tires and take your car down the track.
 
Status
Not open for further replies.
-

Back
Top