518

[Brian Hood]

Heyy All!
Is there a kit or a way to adapt a 518 into an older 727's place? I would like to get OD but I dont know how to control the TCC for lock-up.
Brian
BTW- The donner trans came from a 91 D250. I could not find a tow-haul button any where. It sort of reminded me of a 727 but it have a different tail section. Additionally, it had a 3 pin connecter on the left side above the neutral start in the up right position. Any ideas?
Brian

 

[340mopar]

A three pin will be a lock up, a two pin would be a non lockup. The truck would have had a "OD Off" button on the dash. The '92 B350 van I parted out for the tranny it was next to the headlight switch. it was an orange square button.


Chuck

 

[Brian Hood]

It is a two pin. So does that mean I cant run it on an older application? What kind is it? I put so picts with this thread. Does anyone recognize these casting #'s?
Brian

 

[Brian Hood]

I couldnt seem to get it to load. Anyway, here it is!