Talking to Dave (Mycuda) about the Boot Ring I made for Tim... So this post is for " Mycuda Dave... "(Everyone else just ignore this post as I did not know how to send him photos of a proto type I machined this morning ) but since Dave refferanced my photo of Tim's Boot Ring on this thread... I'm plopping this here... Sorry!
The inside diameter radius is like the factory roadmap floor plate has... For clearance and to give it that "look"... Rather then just a flat plate... And by doing that, I can make the plate thicker...
View attachment 1715153889 View attachment 1715153890
And this bottom photo is the underside... Ball end mill relief spots to clear the screws holding down the Boot to tunnel... This T6061 aluminum Billet is a full .250 (quarter inch) thick... Would take a ton of torquing the screws to bend this !!! Unlike those thin steel ones they sell!!!!
So Dave???? What do You think? I never did find the sketch of the one I made for Tim a few years ago...
View attachment 1715153905
