65 Valiant Convertible Valance

-
tntperk

tntperk

Well-Known Member
Joined
Nov 30, 2011
Messages
130
Reaction score
4
Location
Connecticut
I have a question that I’m sure someone here on FABO can answer for me. I need to replace the rear valance on my 65 Valiant Convertible….. Will a valance from any 65 Valiant fit or does it have to be from a Convertible? Or will one from another year or model A Body fit? Any information you can give me will greatly appreciated. :prayer:
 
You might want to contact this guy as he's parting a '65 Val conv -> http://detroit.craigslist.org/okl/pts/2756054205.html

63 -66 Valiant Convertible Quarter panel - $400 (troy)



I have a rust free 65 Plymouth Valiant convertible for parts. Call Rob 248-202-0281
these parts 63 64 65 66 Plymouth Valiant and Barracuda Formula S. 63 64 65 66 Dodge Dart GT.
not all parts fit all models. this car started out in California and then went to arizona.
fenders $200 each fit 64 65 Cuda and 65 Valiant
doors $200 each fit 63 to 66 Dart and Valiant convertibles will also fit hard tops and barracudas by switching the vent window.
Quarter panels $400 each come with inner and outer wheel wells and trunk extension. these fit 63 to 66 Valiant and barracuda with a little work by the tail lights
driver quarter has a dent and passenger quarter has a very small spot of rust. direct fit 65 valiant convertible also fits 64 to 66 Valiant and 64 to 66 barracuda with very little mods.
Deck lid $100 fit 63 to 66 Valiant
hood $125 fits 63 to 65 valiant
rear frame rails $125 each
front frame rails with inner fenders $200 each
floor pan $250 fits 63 to 66 Dodge and Plymouth A body. side to side but shoet on the front and rear was cut to use in this car.
 
63,64 and 65 Valiant and 64 and 65 Barracuda are the same unless the '65 is a formula "S". It will fit too but has a rectangular notch for the exhaust.
 
Someone told me that only one from a 65 drop top would fit. I had a feeling they were wrong. :cheers:
 
The one on my car looks like Swiss Cheese and someone cut about 2" off with a die grinder.
 
You must log in or register to reply here.
-

Back
Top