[WANTED] 65 Valiant Drive shaft or slip yoke - 904

-
Status
Not open for further replies.
O

Orionsax7

Well-Known Member
Joined
Jul 1, 2005
Messages
242
Reaction score
73
Location
Riverside, CA
Rating - 100%
2   0   0
Contact seller
Yet another part I will need to complete the V8 swap in my slant 6 65 Valiant. I'm putting in a 70's small block 904 and vehicle has 7.25 rear end(I know, will need to be replaced but one thing at a time.) Looking for driveshaft, if you have one available, or if I can't find one, will need a 904 slip yoke so I can measure if I have to order one. Thanks FABO
 
Last edited:
Drive shaft from a 66 valiant should fit 1st year for a slip yoke driveshaft Last year for 106 W/B Valliant's Most were 7 1/4 rears 8 1/4 Drive shaft would be shorter.
 
Orionsax7 said:
Yet another part I will need to complete the V8 swap in my slant 6 65 Valiant. I'm putting in a 70's small block 904 and vehicle has 7.25 rear end(I know, will need to be replaced but one thing at a time.) Looking for driveshaft, if you have one available, or if I can't find one, will need a 904 slip yoke so I can measure if I have to order one. Thanks FABO
Click to expand...
So, 51" center to center on 2 1/4" u-joints?
 
Should be like what would be in a '66 Plymouth A-body with a 904 and a 7 1/4 rear axle.
 
I can get you a slip yoke. The only driveshaft I'd be able to supply would be one longer than what you would need, so, it would have to be shortened.
 
Status
Not open for further replies.
-

Back
Top