7 inch headlamp removal

-
66Valiant528

66Valiant528

FABO Gold Member
FABO Gold Member
Joined
Aug 20, 2019
Messages
1,250
Reaction score
1,033
Location
Medway Ma
So I've ordered front and rear glass bumpers and front brackets . Front bumper loaded was 33.6 pounds. Rear with brackets was 24 pounds. Replacement bumpers are 4 pounds each!
Filler neck was 1# 12ounces. Pulled the vent line and trunk grommet as well. Anyway looking at removing the non functioning headlamps and hardware. No harness in the car so don't go there. I see 7 inch decals available . What are racers doing?

20241026_110601.jpg


20241026_110536.jpg


20241026_110822.jpg
 
66Valiant528 said:
So I've ordered front and rear glass bumpers and front brackets . Front bumper loaded was 33.6 pounds. Rear with brackets was 24 pounds. Replacement bumpers are 4 pounds each!
Filler neck was 1# 12ounces. Pulled the vent line and trunk grommet as well. Anyway looking at removing the non functioning headlamps and hardware. No harness in the car so don't go there. I see 7 inch decals available . What are racers doing?

View attachment 1716319975

View attachment 1716319976

View attachment 1716319977
Click to expand...
Have some aluminum discs made that will fit in the headlight rings. A print shop could print you up some vinyl stickers that look like a headlight. Or buy these.

1729957529176.png
 
I was looking at the decals. Just need to figure out what to attach them to.
 
These are decals on fiberglass. You could cut some aluminum disc as stated above and put the decals on those.
20180207_105416.jpg
 
Before I consult my NHRA rule book can I use aluminum sheet to cover the hole left when I remove this? I'd assume so at a certain minimum thickness like the rear firewall.

20241026_110906.jpg


20241026_110854.jpg
 
You must log in or register to reply here.
-

Back
Top