Sedanman
67-9 Valiant specialist
I have what is left of a 71 dodge dart swinger. It is a 6 cylinder car that still has the engine,trans,radiator,7 1/4 rear axle,front seat,rusty front clip,dutchman panel and dash frame with vin. This car has a clear original 71 title and other matching #'s. The frames and floor are bad but has many good sheet metal parts if you need it like the cowl,firewall,trunk floor,wheel wells,1/4 ext's,rear panel, radiator support,door pillars and misc other stuff. I was going to cut it up and scrap it but figured someone may have some use for it. I hate to scrap parts if someone can use them and not pay amd prices and the parts actually fit right. All of the other parts have been sold from the car. The buyer will have to bring 2 small bolt wheels and tires. I am keeping the other 2 14's that are on it. I will help load it up.
I have but is NOT included is: 2 70-2 trunk lids with wing cut outs,1 front valance,2 rear valances,a set and 1/2 of mid body trim with the rubber insert, 1 set of belt chrome trim that runs along the side glass,2 sets of drip rail chrome and 2 broken grills for 70-1 darts that will be available to the buyer when they come to get the shell. It is for pick up only!
I have but is NOT included is: 2 70-2 trunk lids with wing cut outs,1 front valance,2 rear valances,a set and 1/2 of mid body trim with the rubber insert, 1 set of belt chrome trim that runs along the side glass,2 sets of drip rail chrome and 2 broken grills for 70-1 darts that will be available to the buyer when they come to get the shell. It is for pick up only!
. I cut the front clip off. I have the rad support saved and will be saving the complete firewall/cowl and partial rockers then cutting into the rest and tossing it to the scrap man. I did cut out the marker light sections and will save some of the sheet metal. Does anyone want a free /6 and trans minus intake/exh and related parts? That will go once the body is cut up
