Aftermarket wheel on a 1974 Plymouth Duster

[DukeTheDuster]

Hello everyone! I wanted to know what I need to put this wheel that is a 6 hole on my Duster, is this adapter the only thing I need? Or do I need the grant installation kit too? I don’t know if this will change your answer but my car doesn’t have a horn so I’m not worried about that.

 

[Mopar-Mitch]

You will need the adapter kit too, it has the splines to go on the steering shaft.

 

[Mopar-Mitch]

Also you may need to bend the signal lever back some, as they tend to be too close to the steering wheel when using a flat wheel like that one. I always take the lever off and bend it as to not break the turn signal mechanism.

 

[DukeTheDuster]

You will need the adapter kit too, it has the splines to go on the steering shaft.

So when you say adapter kit, do you mean the grant installation kit? Just wanting to make sure, thanks!

 

[Mopar-Mitch]

So when you say adapter kit, do you mean the grant installation kit? Just wanting to make sure, thanks!

Yes the grant kit should go on first and then the adapter should bolt to the 3 holes in the grant kit.

 

[DukeTheDuster]

Yes the grant kit should go on first and then the adapter should bolt to the 3 holes in the grant kit.

Ok thank you! I’ve been trying to figure this out before I spent any money!

 

[Mopar-Mitch]

Ok thank you! I’ve been trying to figure this out before I spent any money!

You're welcome. I had one very similar to your wheel on a 73 duster and it was set up that way, and the horn button worked.