any body use stuff by pypes?

-
snoreen40

snoreen40

Well-Known Member
Joined
Feb 14, 2010
Messages
154
Reaction score
4
Location
duluth,mn
i just put headers on my car,i have wussy 2 inch pipes on it now, i found PYPES has a full 2 1/2 inch exhaust system with mufflers and x pipe for about 4 bills, oh that is stainless, what do you guys think? or has anyone used this stuff, my exhaust shop will charge me about 300.00 with out x pipe or mufflers(he said ... if he can bend 2 1/2 over my rear diff. )and mild steel
 
Pypes makes a great repop of the A & B Body exhaust tips.....I just put a pair on the Cuda. Excellent quality. :mrgreen:
 
I don't own anything from them but have seen their Set up at Car shows. Everything was very nice looking. Not 100% but i think their stuff is made in the U.S.A too?
 
I sure hope their better than they were 2 yrs. ago because I bought one of their 2-1/2" stainless kits (btw: it's cheap stainless, not polished, except the mufflers) for my 68 Cuda and it didn't fit worth a crap. The X pipe was made so narrow it wouldn't even clear the yoke on the rearend and mine has the small yoke. I realize that when the car is sitting on the ground the yoke is higher than the exhaust but I want it to not rip the exhaust off when I jack the car up so I had to take it to a shop to get the X pipe re-bent. Then we went to install the tail pipes. The left fit ok but the right hung down much farther at the rear (5-6 inches). Took it back off and re-bent it. Finally got it fitting and looking decent after 2 days work and $100 to the exhaust shop.

Check out this thread about Pypes exhaust

http://www.forabodiesonly.com/mopar/showthread.php?t=31883&highlight=pypes+exhaust
 
I used the 2 1/2" x-pipe kit with cutouts on my Duster and I love it. I bought Dynomax Ultraflo Welded mufflers too. I installed the kit and got it to fit perfectly then drove it to the muffler shop to have the pipes bent from the mufflers back to the tips. No regrets...
 
You must log in or register to reply here.
-

Back
Top